91麻豆国产语对白在线观看_日本成人三级在线播放_日韩AV在线第一页_2020久久精品亚洲_两个人的视频免费观看高清日本_免费3D动漫无码网站_麻豆剧果冻传媒精品_丁香婷婷深情五月深爱六月_午夜福利小视频网站_亚洲国产熟妇乱伦视频

Vibration plate manufacturers briefly introduce the purpose of the vibration plate:

1. Automatically sort the workpieces and automatically feed them to the assembly machine, instead of tedious manual manual sequencing, especially the arrangement of small and ultra-small workpieces that are not easy to operate manually.

2. Sort out unqualified workpieces

3.Accelerate production speed and improve efficiency

4. The use of a vibration plate can reduce the number of labor, improve labor efficiency, and reduce operating errors.

5. Vibration discs for products with particularly high hygiene requirements are less likely to cause pollution than artificial production, and can also improve the overall image of the factory.

Equipped with relevant automated machinery and equipment, the vibrating plate can partially or completely replace labor, realizing fast, accurate and smooth automatic loading and automatic assembly of the production process

Vibration plate adjustment steps:

1. Make sure that the vibration body is located on the surface of the disk and is locked.

2.Turn the controller button to the middle position or to the number 130 ~ 180;

3. Turn on the power and check whether the conveying speed of the vibration plate reaches the requirements;

4. If it does not meet the requirements, do not disconnect the power, loosen any one of the fixing screws of the lock shrapnel, and check the vibration speed change;

5. If you loosen the elastic screw of the elastic sheet and the vibration speed becomes faster, it means that the elastic sheet is too thick, and the number of elastic sheets or the thickness of the elastic sheet should be reduced moderately, then go to step 4 and debug again;

6. If you loosen the fixing screws of the shrapnel and the vibration speed becomes slower, it means that the shrapnel is too thin. After increasing the number or thickness of shrapnel moderately, go to step 4 and debug again;

7. If the adjustment of step 4, the vibration speed does not change much, it means that the shrapnel adjustment has been completed;

8. The electromagnets should be aligned, the gap should be 1-1.5 mm, and the gap should be parallel.